3D Touches is an auto leveling sensor for 3D Printers that can precisely measure the tilt of your print surface. It can greatly improve the printing precision of your 3D Printer.
3D Touches The main functions and controls of 3DTouches are the same as most auto bed leveling sensors, which consists of a RC servo and a Micro-switch, thus, 3DTouches can be used on almost every 3D printer control board.
By using progressively designed solenoid and hall sensor, 3DTouches can integrate high precision in such a simple structure. To make it more user-friendly and to bring you more enjoyable printing experience we add many smart functions such as self-test, false alarm, alarm release and test mode for M119.
wide Selection of Bed: Does not uses either optical, nor proximity (inductive/capacitive) sensor. It is controlled by Hall Effect, providing high precision. Thus the bed material can be selected freely.
Optimized structure: Larger Build Size: It is a small and technology-intensive one. Build size can be set larger than other existing auto bed leveling sensor. Uses existing RC Servo motor signal intactly, so just plug on the same pins after removing servo motor.
3DTouches can be easily applied, since it has a small and simple structure. Gathering information & firmware setting will be an easy task, because 3DTouches works as usual auto bed leveling sensor.
Self-test: The push pin is operated three times to test when the power is on
Alarm: The LED light blinks if a problem found on a self-test or on an operation
3DTouches' Standard Deviation in repeatability is around 0.005mm, at that precise.
If you choose 3DTouches, your 3D printer will be high-class masterpiece, giving you an enjoyable experience.
4. Innovative Solenoid: Ultra Power Saving
On idle state, while the push-pin is whether pulled out or retracted, there are not any electric current flowing on solenoid, and standby electric current in the whole device is below 15mA on average, whereas on working state, while the pin is moving in sudden about 100ms, under 300mA flows in the device.
Low power consumption even further drops joule heating, preventing from heat problem.
Max. Current: 300mA
Cable length: 150mm
3-pin: Brown (-, GND), Red (+5V), Orange (control signal)
2-pin: Black (-, GND), White (Z min)
1 set x 3D Touch Auto leveling sensor kit
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.