· After many tests remote control won't cloning, or cloning successful, but not operate the gates.
Can be few reasons:
1. Your original remote control battery is low power. (even if working fine)
Solution - Change new battery. (If you got multimeter check voltage. If voltage less than 1 Volt battery no good even if new. For example Battery must be 12V you got 11V)
2. Please make sure factory testing code is deleted, before start cloning.
If code clearance done properly, short press any button. Light won't flash at all.
If light flash when short press any button clearance process done wrong. Please repeat clearance process again.
3. When cloning led blink twice and no more.
868Mhz frequency remotes controls match harder clone, than any other frequency remote controls. Please be patient. Don't decide remote is faulty. All remotes deep tested before despatch and 100% working order.
You must find the best cloning position. In most cases the best position is back to back. But not always. On different models may be you need use other positions (face to face, side to side, like T position and etc.) Please watch video bellow. As you see on video first button clone ok, second button not (video time 0.22s) led blink twice and no more. Only when i moved remote down just a little cloned successfully